What it is
Asphalt slurry seal is a cold-applied mix of asphalt emulsion, fine crushed aggregate, water and additives spread in a thin layer over existing pavement. It fills surface voids, restores skid resistance and seals out water and UV — a step up in toughness from a standard seal coat.
It is the go-to treatment for HOA streets, private roads, and busy drive aisles where pavement is still structurally sound but the surface is oxidized, raveling or showing fine cracks.
City Service Paving project process
- 1Walk the streets and drive aisles to confirm the base is sound enough for slurry.
- 2Crack sealing and dig-out repairs on failed areas before any slurry goes down.
- 3Resident and tenant notices plus phased closure plan.
- 4Sweep and clean; protect gutters, utility covers and concrete edges.
- 5Apply Type I or Type II slurry based on traffic and surface texture.
- 6Cure, then re-stripe, stencil and reset markers.
When your property needs it
Consider slurry seal when the surface has turned gray, aggregate is loosening, or hairline cracking is spreading — but before alligator cracking and potholes appear. Most HOA streets benefit from slurry every 5–7 years as part of the reserve plan.
What's included
- Pre-slurry crack seal & patching
- Type I or Type II slurry mix
- Resident / tenant notifications
- Phased closures
- Utility and concrete protection
- Re-striping & stenciling
- Reserve-study friendly scope
- Written estimate
